Product details and matters needing attention:
The connecting shaft and motor shaft connected directly, when motor
starts running, drive the connecting shaft and a set of working on
the connection shaft of the mill. For material from the hopper into
the grinding powder, mill spindle and grinding sets of relative
operation, ground into small pieces of material particle crushing
force;After ground spiral motion of small particles in the mill was
brought into the two piece of grinding, grinding indented relative
to the operation, make the material in a short period of time were
shattered into tiny particles (powder); Powder from grinding tooth
ditch and thrown around .At the same time being loaded on the mill
powder plate down, flowing from powder outlet.
20 - 40 kg/h
operation and adjustment:
1.Mill should be placed at the levels of fixed, robust desktop or
table, solid wood is better. Iron plate under the bottom of motor
with four screw holes. motor iron plate with long screw through the
screw holes firmly fixed on the desktop or table ; It is more
better if fix rubber mat between motor and desktop, which can
reduce vibration, achieve better mute effect.
2.motor cover should be fixed on the desktop ,make the motor cover
and plate separate,to prevent the vibration and resonance between
iron plate and motor , then tighten motor cover by short screw.
3.open the cover, then put millsone fix on the connection shaft ,
pressing with two thumbs on the mill , if the mill can free
stretch,that proof mill and connecting shaft cooperate well. Colse
the cover ,tighten screw , check the power supply, turn on the
switch, check whether the mill Operation specified
direction,sound,shake is running normal . if there is any abnormal
sound or vibration, should shutdown check, until returned to
normal, can be restarted.
4.Open the mains,work about 1minutes, put material into chute.
Twist regulator to appropriate location. open blanking
baffle,material can slowly flowing to grinding chamber. damper to
open a little bit small, To avoid feed fast,jammed motor.Generally
speaking ordinary materials needs grinding two times, one is Coarse
grinding, another is fine grinding.
5.milling thickness can adjustment by yourself ,which is depends on
clearance between two pieces of grinding, the grinding of the
clearance by regulator to control, according to order the thickness
on the cover, when the regulator to the direction of the fine
adjustment, two grinding gap narrowed, flour is thinner;Otherwise
the grinding powder coarsening.
6.strength of regulator adjusting range and how to control, can
through the ears to hear the sound of abrasive disc friction and
the voice of the motor running, grinding, the more closer louder
voice and even sharper; Conversely, grinding or not closer
separation, voice is soft.
7.separate grinding is particularly high oil content of the
material such as sesame seed, walnut, peanut, oil content is
extremely high,so this kind of material can only be grinding coarse
, because these material has a large number of oil filters through,
will make powder slurry. So grinding materials particularly high
oil content, governor don't adjust too tight, mill piece clearance
stay somewhat close to or even completely separate, can be ground
into powder (granule). Above material if need to wear very thin,
need material with no oily or low oil content, high oil content and
low oil content the proportion of the material as follows: 1:1:4 to
5, and take the ground twice, the first time, coarse grinding, fine
8.Install about Static grinding and dynamic grinding:
Dynamic grinding assemble in millstone ,Static grinding assemble in
crush cavity. will be fixed grinding three screws removed, the
grinding can be unloaded. The hardness of grinding is made of cast
iron, cast iron is about 52 °, the hardness, flexibility is poor.
With mill, screw can not be screwed too tight, in case of grinding